CM032F Sniper Rifle Replica
CM032 replica made from metal and polymer. The receiver and some internal parts are made from ABS. Metal parts include the bolt carrier, iron sights and external barrel. The stock has a comfortable, rubber stock pad that prevents the replica from slipping. Aside from the magazine, majority of assembly elements and the trigger guard were also made from steel. The cheek pad located on the stock was made from polymer. Its adjustment is done by sliding it and it is kept in place by steel screws. Cheek pads are especially useful if one uses aiming devices on high mounts. Front 22 mm mounting rail was made from metal.
The replica has a smooth, nice to the touch cradle. Iron sights consist of an open, vivid front sight and a vertically and horizontally adjustable rear sight.CM032F replica features a metal bolt, whose reloading sound can pleasantly surprise every player. Additional advantages of this replica include an operational mechanism that locks the bolt in rear position, however, in order for the bolt to remain in the back, first it needs to be pulled back, the bolt catch needs to be pressed (the paddle is located on the left side of the replica) and only then can the bolt be released. In order to release the bolt from its rear position all that is required is to pull back the bolt without pressing the bolt catch paddle.
Inside the replica is a gearbox V7 that allows to fire in semi- and full-auto modes. Thanks to a long barrel, the replica has good accuracy and range. Hop-Up adjustment is conducted using a knob located above the magazine well.
The battery is stored inside the stock of the replica. Access to the chamber is gained by removing the stock pad and spacers from the stock as well as removing the assembly screws and removal of the last piece.
The set includes:
- cleaning rod
- package of test BBs
Replika karabinu wyborowego CM032F
It is the spped of bb, while its leaving the innerbarrel of replica. This speed is measured in FPS (Feet Per Second).
1 FPS = 0,3 m/s
1 J = 99 m/s
1 J = 326,7 FPS
|Propulsion / Powered by:|
Indications v2, v3, v6 does not mean the level of advance, but only shape of gearbox skeleton which was used and selected by the manufacturer depending on the capabilities of the body of the replica. For example, a models of the M4/M16 family, MP5, have a v2 gearbox, while the AK family have gearbox v3.
|Type of fire:|
Metal + plastic + steel
The length of the replca is measured between the two most distant points of each other. Different models have several of these values, because of its design allows to increase or decrease it length (eg. folding stock or extended flash hider).
|Inner barrel length [mm]:|
This is a value that includes the weight of the replica, magazine and other accessories that are include in set without a battery, charger, cleaning rod, etc., etc.
|Battery Voltage [V]:|
|Battery Capacity [mAh]:|
Battery capacity determines the time, which it accumulated enough energy to work gearbox. The greater capacity, then replica will shoot longer.
rechargeable battery is characterized by high efficiency
current-carrying capacity, but there are disruptive effect on memory.
Should be unloaded and loaded in the full cycle, ie, it is recommended
to fully discharge, and after unloading must charge the battery
immediately without leaving it for a long time in a discharged state.
|Magazine capacity [pcs]:|
Hop-Up system is used for overclocking bb during the shot (putting it in rotation), through which, it extends its flight path. Acting laws of physics make that bb lift up, while the gravitational force take it down. Appropriate adjustment of Hop-Up, will compensate for these two factors, which result in long and straight flight for longer distance and be greater focus shot (to improve accuracy).
Blow back is a simulation system of the cocking lever - it imitates the work of it as the equivalent sharp. This system raises the realism and adds a lot more experience during shooting.