LiPo 7.4 V 250mAh 25C HP – JST Battery
Designed especially with Valken V-12 motors in mind, a small LiPo 7.4V packet measuring 10x20x40 mm. The packet features male-ended JTS connector. High quality of constituent parts and small power drain in V-12 motors allow this battery to function for a long time on a single charge. Thanks to its compact size it can be used not only with HP motors, but also as a power source for electric pistol replicas (AEP).
Lithium-Ion-Polymer (LiPo) packs are successors to the known Lithium-Ion (LiIon) packs. The basic advantage of LiPo is undoubtedly the ratio of capacity to size. The packs are of very small size whilst maintaining a very large electric efficiency, which allows for choosing an appropriate pack for practically every AEG replica. Do not feature memory effect. Can be charged very frequently, without the need to be fully discharged. Frequent charging is beneficial for every type of a battery.
It is crucial to remember not to discharge a LiPo pack to a level of less than 3V per cell and not to overcharge over 4,2V per cell. Another advantage of LiPo packs is a small percentage rate of self-discharge. Unused pack will lose approximately 3-5% of energy per month. It is important to pay attention to an unused pack as there is a risk that as a result of not being used over a prolonged period of time it can be discharged beneath the acceptable minimal value (3V per cell) and inadvertent chemical reactions may occur, which lead to a deterioration of the pack’s properties including a permanent damage and, in extreme cases, fire. Unused LiPo pack should be charged to an average of 70%.
Properly used, a LiPo pack has an exploitation period of on average 500-700 cycles. An important factor is the temperature that LiPo packs can work in. In contrast to other batteries, LiPo cells perform well in low temperatures. However, they should be charged in room temperature. In order to maintain the good condition of LiPo batteries it is required to balance them during charging with a service connector, which most LiPo packs have (a good LiPo charger features an in-built balancer).
Battery capacity [mAh] Battery capacity determines the time, which it accumulated enough energy to work gearbox. The greater capacity, then replica will shoot longer. | 250 |
| Battery voltage [V] | 7.40 |
| Product height [cm] | 1 |
| Product length [cm] | 4 |
| Product weight [g] | 50 |
| Product width [cm] | 2 |
| Number of cells | 2 |
| Type of cells | Li-Po |