Arcturus LWT MK-I CQB 10" AEG SPORT SE™ airsoft Carbine
The airsoft carbine from Arcturus model LWTMK-I CQB 10" AEG SPORT SE™ has been made primarily using PA66 Nylon, which has been reinforced with fibreglass.
The slide ring, the screws at the handguard, the tactical sling mount, the QD mount, and the dummy slide were made from steel . At the same time, the discharge device, manipulators (bolt-catch, selector, magazine catch), reloading levers were made of aluminium . PA66 nylon is used for the barrel with a 10-inch-long M-LOK handguard. On the handguard we additionally find RIS rails. The RIS rails are also nylon: both on the handguard and on the barrel. There is an ergonomic pistol grip, which has a rough surface, a magazine, an ergonomic, adjustable buttstock, which accommodates the battery and folding sights.
The replica is lightweight, well-fitted and balanced, its interior provides very good performance in its factory configuration and a good base for tuning.
Inside the replica we will find, among others:
- Steel cylinder
- Gearbox V2 with quick-change spring system
- Polymer spring guide
- Reinforced Gearbox front
- Polymer nozzle
- 23T motor (ferrite)
- 18:1 gears
- Hop-up rotary unit
- SE optical control system
The model belongs to the SE or Standard Enhanced series, which means that the replica has been equipped with a programmable optical control unit.
Functions of the SE ETU optical system:
- Pre-Cocking (2 stages)
- Active Break (2 stages)
- Progressive trigger
- Programmable fire modes
- Binary trigger with Ramping
- Low Battery Protection
- Electronic fuse
Package include:
- Cleaning rod
- Hi-Cap Magazine
- Replica
- Allen key
- Iron sights
- Small Tamyia - Deans adapter
Package exclude:
- The set does not include the battery nor charger
| Colour | Half-Tan |
Battery included NiCd
rechargeable battery is characterized by high efficiency
current-carrying capacity, but there are disruptive effect on memory.
Should be unloaded and loaded in the full cycle, ie, it is recommended
to fully discharge, and after unloading must charge the battery
immediately without leaving it for a long time in a discharged state. | No |
| Blow Back Blow back is a simulation system of the cocking lever - it imitates the work of it as the equivalent sharp. This system raises the realism and adds a lot more experience during shooting. | No |
| Product length [cm] | 82 |
| Product weight [g] | 2115 |
| Power supply | Electric |
| Material | Aluminum Plastic |
| Made of | Steel |
| Muzzle velocity [FPS] It is the spped of bb, while its leaving the innerbarrel of replica. This speed is measured in FPS (Feet Per Second). 1 FPS = 0,3 m/s 1 J = 99 m/s 1 J = 326,7 FPS | 410 |
| Fire mode | Full-auto Adjusted burst Semi-auto |